Contents:
Accessories First time use Check to make sure you have the following accessories before disposing of the packing material. Power Cord Remote Control 1.5V batteries Table Top Stand (50″ included) For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv Table Top Stand (42 included) Two AA size, Note: Please visit our website for optional accessories. CAUTION:1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical. 2. This stand for use only with Hitachi P42T501 and P50T501. Use with other apparatus is capable of resulting in instability causing possible injury. Remote Control Unit CLU-4371A (Part No. HL02401). Two “AA” size, 1.5V batteries. Table Top Stand (UX27662 42″ model) Power Cord (P# EV01841). 1.Open the battery cover of the remote control by pushing down and sliding the back cover off. 2.Insert two new AA size batteries for the remote control.When replacing old batteries,push them towards the springs and lift them out. 3.Match the batteries to the (+)and (-)marks in the battery compartment. 4.Insert the bottom of the battery,the (-)side,into the battery compartment first,push towards the springs and insert the top of the battery,the (+)side,into place.Do not force the battery into the battery compartment. 5.Replace the cover. Bottom View (Remote Control) Lift up on tab to remove back cover. REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT CAUTION:Do not insert batteries with + and - polarities reversed as this may cause the batteries to swell or rupture resulting in leakage. (UX27282 50″ model). 3.The wall mount unit for the 50″and 42″models is WM07S and for the 55″models is WM07L.Please see page 7 & 8 for important information related to the wall mount.Wall Mout unit is an optional accessory (Not Included). Securing to a table-top 1.Using wood screws (two)fasten the set to the clamping screw holes on the rear of the Plasma TV stand as shown below. 2.Using commercially available wood screws,secure the set firmly in position. Securing to a Wall 1.Keep the Plasma television 4 inches away from the wall except when mounted using the wall mount bracket. 2.Secure the television to the wall as shown . NOTE: TheTableTop Stand for model P55T501 is not included (Optional). To take measures to prevent the Plasma Television from tipping over and prevent possible injury it is important to mount the unit in a stable and flat surface. How To Set Up Your New Hitachi Plasma Television Wood screw two places Wire 55
File Details: February 28, 2007 7.1Mb (72 pages)
Source: www.hitachi.ca
