Installation Instructions for FORD FOCUS

Posted on | September 6, 2007 | View Comments

Contents:
Tools & Materials Needed: 1. Utility Knife 7. Crank Spring Removal Tool 2. Wire Crimper (Special Tool, available at most 3. Torx™ Wrenches Auto Parts Stores) – or – 4. Hex Nut Drivers 8. Flat Screw Drivers (2) 5. Drill and Bits 9. Add-A-Circuit™ fuse adapter 6. Phillips Head Screw Driver 10. Silicon Sealant (Clear or Black) A. Removing the Door Panel Coverings 1. For ease of installation, do both sides at the same time. 2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove
the spring, located in a slot on the back of the crank. 3. Remove the cover plate for the remote-control mirror, which is held in place by 3 spring clips. Remove by gently pulling the front corner of the cover out, and then slide the cover back. 4. Remove the door Pull-handle cover, by inserting a screwdriver into the access hole on the bottom of the handle, and using the screwdriver as a lever, pop off the handle cover. 5. Remove the button covering a retaining screw in the interior door latch backing plate. 6. Remove the 8 Torx™ retaining screws around the perimeter of the door panel, and the single Torx™ retaining screw in the interior door latch.

File Details: February 20, 2004 162kb (4 pages)
Source: a1electric.com

View or Download

Click to report broken post.